This should be at a very slow speed. I can't belive the subframe had to be dropped. You're brave Thanks for the rough write-up. This is not a class-action. And yes, the dealer is trying to get out of repairing the transmission.
There is a hose on the intake tho connects to the engine. You will need a variety of sockets from 10mm up to 32mm. Let the adjuster investigate and O. You will have to mate the 2 at an angle. It is possible that the transmission was damaged by an impact or water damage, which would not be covered. Use a 19mm socket and ratchet to hold the flex plate in place using the crank pulley bolt on the passenger side of the engine.
The information provided on this website and pages is not intended to create an attorney-client relationship between you and The Law Offices of William R. Some heads are on the side of driver, other heads side of passenger. Their employees are poorly trained and poorly paid, are not actually real technicians in most cases, and are pushed to the limit to get cars in and out as fast as possible. That, however, does not mean that the transmission is malfunctioning. I have looked for schematics of this car online and have not found anything. This is not a class-action.
I finally got the trans on, what a nightmare. Any help would be appreciated. By now you should have a bare sumframe with control arms only, trans only held in place by the top mount and one bolt. There is one 10mm bolt holding a bracket on the subframe with the o2 sensor wirining remove the bracket along with a plastic retaining clip on the subframe. When got out of car, there was transmission fluid all over drive.
I finally got the trans out. I am mechanically inclined, have swapped trans and engines before, but this Sentra is not going as smoothly. I recommend spraying the bottom part of the hub where it clamps to the control arm with wd-40 prior to removing it. This will take some time or will go on super easy. Law Offices of William R. They are aware of this problem and just keep replacing it with rebuilt transmissions.
Well, the car is an '08 so it could have been sold in '07. I hope it goes a lot smoother. Also remove a tiny splash cover in the wheel well of front left tire. You should not rely on any of the information contained on this website without seeking the advice of an attorney. Should be interesting to say the least. The sway bar is connected to the subframe Loosen up all the subframe bolts but do not remove them.
We need a bit more info. Second idea: I lift the passanger side of the engine just enough to tilt the trans To clear the subframe. You should not rely on any of the information contained on this website without seeking the advice of an attorney. Just need to put fluid in the car. So I will be able to make a full write up. It is heavy so i suggest you hold one side up and someone else hold another side up so it doesn't slam on you or the ground. Once the converter stud thicker stud pops through the flex plate and the dowel pins are slightly in the trans, you can start threading trans bolts in.
Many owners call us with no permanent fix every being done for their Nissan! The '08 Sentra probably had two transmission choices, depending on the motor. Plug both hoses up that lead to the engine and plug up both lines on the trans. You can also remove the wires from the starter and completely remove it. The State Bar rules require attorney offices to designate a single attorney responsible for this site. I have removed every single thing, trans mounts, trans bolts to block, everything. Just slide the starter out of the block and let it hang.
If you are not satisfied with what the Nissan dealer told you, then you may want to pursue the issue with Nissan Customer Service. Listed client testimonials do not constitute a guarantee, warranty, or prediction regarding the outcome of your legal matter if you were to become a client of our law firm. The State Bar rules require attorney offices to designate a single attorney responsible for this site. McGee as the attorney responsible for this site. Remove the shift cable selector. There are a total of 6 subframe bolts.