Install output shaft tail bearing on to out put shaft using Installer L-4411. Remove the side cover from case. Some air fresheners will damage the finish of painted or decorated parts if allowed to directly contact any surface. Unplug the downstream O2 sensor connector. No chemical flushes should be used in any power steering system; only the approved lubricant may be used. Remove bearing cup by hand 1 or by using a pick. Your body could strike the inside surfaces of the vehicle in a collision, increasing head and neck injury.
Turn on the Hazard Warning flasher. Remove the rear engine mount through bolt 2. Unburned fuel could enter the catalytic converter and once the engine has started, ignite and damage the converter and vehicle. Remove air cleaner assembly 1. An electrical connection was repaired to correct this. Your motorized door or gate will open and close while you are training the Universal Transceiver. Be careful of the moving belts and fan.
To prevent damage to the starter, do not crank the engine for more than 15 seconds at a time. You could lose control of the vehicle and possibly have an accident. . Move the safety catch located under the front edge of the hood, near the center and raise the hood. Unlatch the wire clasp securing the bulb into the housing and rotate it into the position shown.
Vehicles and other objects seen in the passenger side convex mirror will look smaller and farther away than they really are. Unsupervised use of vehicle equipment may cause severe per- sonal injuries and death. To unlock the door, turn the key to the left. This device must accept any interference that may be received including interference that may cause undesired operation. To loosen the lap belt if it is too tight, pull on the lap belt.
The label contains the following information: Name of manufacturer Month and year of manufacture. Use of these devices while driving can cause an accident due to distrac- tion, resulting in death or injury. Install output side spool shaft bearing using Installer C-3095-A. A hot engine cooling system is dangerous. Rear Door Storage Front Door Storage.
The belt webbing retractor is designed to lock during very sudden stops or collisions. It is extremely dangerous to ride in a cargo area, inside or outside of a vehicle. Using an inch pound torque wrench check and Pinion Nut Socket 9921 1 check the rotating torque, it should be 30 in. Do not attempt to cross any large obstacle with steep sides at an angle great enough to put the vehicle at risk of a roll over. Do not attempt to push or tow your vehicle to get it started. Vehicle recovery should always be given consideration before attempting a questionable obstacle. Use only recommended brake fluids or equivalent.
Steering shaft pinch bolt Fig. A lap belt worn too high can increase the risk of internal injury in a collision. The front locations are outlined by two triangular cutouts, the rear locations by two rectangular cutouts. Aftermarket parts, especially heavy duty or heat resistant parts, will allow drivers to move beyond casual driving and engage in the rough and tumble that Jeeps are known for, including mudding, rock crawling, and off-road excursions. Use the Automatic Unlock Doors On Exit feature in accordance with local laws. Tighten the bolts to 81 ft.
Folding Rear Seat Rear Seats Folded Flat Reclining Rear Seat —. Repeat these steps if you want to return this feature to its previous setting. After the Ready prompt and the following beep, say Setup Select Phone and follow the prompts. Always use washer fluid when using the wipers to remove salt or dirt from a dry windshield. Lower screw jack 2 until rear mount through bolt can be installed.