Ccna 1 v5 chapter 8 answers. CCNA 1 (v5.1 + v6.0) Chapter 8 Exam Answers 2017 2019-05-04

ccna 1 v5 chapter 8 answers

CCNA 1 (v5.1 + v6.0) Chapter 8 Exam Answers 2017

ccna 1 v5 chapter 8 answers

Measurements that are performed during particular circumstances such as main network device restart or after working hours will result in an inaccurate set of characteristics for the purpose of a baseline. A baseline is used to establish normal network or system performance. A network administrator has issued the shown commands. From year to year, Cisco has updated many versions with difference questions. What is the decimal equivalent of the hex number 0x3F? At what point would a router, which is in the path to the destination device, stop forwarding the packet? Not all options are used. You can review all chapter 8 Exam Answers.

Next

CCNA 1 (v5.1 + v6.0) Chapter 8 Exam Answers 2019

ccna 1 v5 chapter 8 answers

The address pool is configured with 192. A message is sent to all hosts on a remote network. All of the other layers should be investigated. Thus, 5 host bits are needed. Given the network address of 192.

Next

CCNA 4 Chapter 8 Exam Answers 2019 (v5.0.3 + v6.0)

ccna 1 v5 chapter 8 answers

What impact does this command have? Which feature will allow different communication streams to occur at the same time, without having a single data stream using all available bandwidth? Not all options are used. Which single subnet mask would make the most efficient use of the available addresses to use for the four subnetworks? All hosts on the local link are available. . The left router connects network B with 50 hosts and network C with 25 hosts. A network engineer needs to verify that the setup is correct and that the authentication is indeed encrypted. What is a characteristic of manual route summarization? Which statement is supported by the output? The ping command can be used to verify connectivity to other network devices.

Next

CCNA 1 (v5.1 + v6.0) Chapter 8 Exam Answers 2017

ccna 1 v5 chapter 8 answers

What is the target of this packet? It can be used to compare with future network or system performances in order to detect abnormal situations. . . From year to year, Cisco has updated many versions with difference questions. How many host addresses are available on the network 172. Which configuration should be entered into the properties of the workgroup server to allow connectivity to the Internet? What is the result of this command? This address is not included in the routing table and is not defined by the network command. The address pool is configured with 192.

Next

CCNA 1 (v5.1 + v6.0) Chapter 8 Exam Answers 2019

ccna 1 v5 chapter 8 answers

There is a broadcast domain on each switch interface. Given the network address of 192. Subnet D needs 14 addresses, so it wastes 16 addresses. We recommend you to go thought all version if you are not clear. Broadcast traffic is not permitted to cross the router and therefore will be contained within the respective subnets where it originated.

Next

CCNA 1 v6.0 ITN Chapter 8 Exam Answers 2019

ccna 1 v5 chapter 8 answers

Running configuration files can not be deleted nor are they saved automatically. Since other computers on the same network work properly, the default gateway router has a default route and the link between the workgroup switch and the router works. Network C needs to use 192. Subnets do not simplify network design. Which two commands can be used on a Windows host to display the routing table? Not all options are used. Given the network address of 192. Given the network address of 192.

Next

CCNA 1 Chapter 8 v5 Exam Answers 2016

ccna 1 v5 chapter 8 answers

Network C needs to use 192. We recommend you to go thought all version if you are not clear. Broadcast traffic is not permitted to cross the router and therefore will be contained within the respective subnets where it originated. Not all options are used. A multicast message is a message sent to a selected group of hosts that are part of a subscribing multicast group. A company uses the address block of 128.

Next

CCNA 1 VERSION 5.1 CHAPTER 8 EXAM ANSWERS 2016 (100%)

ccna 1 v5 chapter 8 answers

Consequently, it wastes 28 addresses. Which configuration should be entered into the properties of the workgroup server to allow connectivity to the Internet? The0and 4 parameters specify ports 0 through 4, or a maximum of five simultaneous Telnet connections. . . What are two reasons a network administrator might want to create subnets? The company wants to create two subnetworks that would contain 10 hosts and 18 hosts respectively. A network technician tests the link with a cable analyzer and notices that the workstation sends an excessive number of frames smaller than 64 bytes and also other meaningless frames. Not all targets are used.

Next