See your dealer or qualified service technician for more information on tire cables for your vehicle. It will make you up-to-date and give lot of valuable knowledge about your 1998 Ford Explorer Now you don't have to rely on your mechanic for the simplest repair. Anti-theftsystem if equipped Refer to Anti-theftsystem in the Controls and features chapter. If the Check Engine light remains on, have your vehicle serviced at the first available opportunity. Do not remove ice from the mirrors with a scraper or attempt to readjust the mirror glass if it is frozen in place.
Move the control in the direction you wish to tilt the mirror. Press the defroster control to clear the rear window of thin ice and fog. Controls and features High beams Push forward to activate. If you do not install and use the safety seat properly, the child may be injured in a sudden stop or collision. If you must use a forward-facingchild seat in the front seat, move seat all the way back. However, the air conditioning will only function if the outside temperature is about 10°C 50°F or above. Place gearshift lever in P Park or in the reverse gear manual transmission.
It is only intended for off-road applications that require extra power including deep sand, steep grades and pulling a boat and trailer out of the water. It can be used to clear ice or fog from the windshield. Remove the jumper cables in reverse order. Seating and safety restraints If the air bag is inflated, the air bag will not function again and must be replaced immediately. Refer to Driving while you tow in this chapter.
Always set the parking brake fully and make sure the gearshift is latched in P Park. Each time the vehicle is started, the transmission will automatically return to normal overdrive mode. Speed control may shut off if you are towing on long, steep grades. Working with the engine off ² Automatic transmission: 1. Refer to Driving while you tow in this chapter. Fan speed Controls and features remains automatic unless the fan speed thumbwheel is turned or the steering wheel fan speed control is pressed. P Park Always come to a complete stop before shifting into P Park.
Use a frame-mountedweight distributing hitch for trailers over 1 590 kg 3 500 lb. The rear axle is filled with a synthetic lubricant and does not normally require a lubricant change for the life of the vehicle. They may obstruct your vision or strike occupants of the vehicle in the case of a sudden stop or collision. ² The hazard lights control is located on top of the steering column. The power distribution box contains high-currentfuses that protect your vehicle's main electrical systems from overloads. The liftgate door and window should be closed before driving your vehicle. The passenger cannot protect the child from injury in a collision.
Parking brake Apply the parking brake whenever the vehicle is parked. Always drive and ride with your seatback upright and the lap belt snug and low across the hips. Do not use extensions to change the fit of the shoulder belt across the torso. Replace the flat tire with the spare tire, making sure the valve stem is facing outward. Turn off the engine and remove the key. You can override automatic operation with any of the override controls, the fan speed control or the steering wheel controls.
To lower the shoulder belt height, push the button and slide the height control down. To put the retractor in the automatic locking mode, grasp the shoulder portion of the belt and pull downward until all of the belt is extracted and a click is heard. Your vehicle must be moving in order for this display to function properly. Why to buy Digital Service Manual from us? Eliminate frequent shifting by shifting out of Overdrive into D Drive. Use only recommended engine oils. Rather, it means the forces were not of the type sufficient to cause activation.
The horn will chirp to confirm procedure is complete. Depress the clutch and place the gearshift in 1 First. Always come to a complete stop before shifting into and out of R Reverse. Wet brakes do not stop the vehicle as effectively as dry brakes. To install the shade: 1. Seating and safety restraints 2. Check all battery terminals and remove any excessive corrosion before you attach the battery cables.
Location of the spare tire and tools The spare tire and tools for your vehicle are stowed in the following locations: Tool Location Spare tire Under the vehicle, just in front of the rear bumper Jack, lug nut wrench Left rear quarter panel behind interior trim Jack handle Behind rear seats, under carpet Removing the spare tire 1. The doors will lock again, the horn will chirp and the lamps will flash. Tighten the anchor according to specifications. Use a load carrying hitch. Spare SecuriLock y keys can be purchased from your dealership and programmed to your SecuriLock y anti-theftsystem. Do not drive if you smell exhaust fumes.